Stoving enamel, temperature resistant up to 650°C
| Colours: other colours available on request (volume dependent) | 9104 Flat Black, 9103 Inox Black |
| Appearance when dry | Mat, mat-satin, satin |
| Packaging | 5 KG / 20 KG |
| Max operating temperature | 300°C – 650°C colour dependant |
| Solid matter content (by weight) depending on formulation | 50-60% |
| Surface preparation | Good results can be obtained with thorough degreasing, cleaning and mechanical removal of all traces of rust but surface blasting in accordance with SA 2 ½ is advised |
| Application | Apply using a low pressure conventional spray gun (with or without electrostatic spraying equipment) |
| Application conditions | +5°C and surface temperature at 3°C above dew point |
| Theoretical coverage (depending on formulation) | 10-20 m²/L for dry film thickness of 25 μm |
| Recommended film thickness | 15 – 25 μm (higher film thickness may result in boiling defects and loss of adhesion after heating) |
| Recommended drying conditions | Oven drying: Minimum 20 minutes at 200°C |
| Shelf Life / Storage Conditions (+5C° < T < 35°) |
6 months in original unopened packaging, protected from moisture, extreme cold and excessive heat |
Established in 1969 PLPCOATINGS has continually extended its knowledge in a diverse range of surface treatments.
All products are a result of extensive research and development and currently used by Europe’s leading manufacturers.